I plant the production of D-type vertical bucket elevator, By moving parts (hopper and traction belt), The upper part of the section, with the driving drum The lower part of the section with tensioning roller Intermediate casing, Driving device Check Brake and so on (see the figure below), Suitable for the upward transportation powder magnetism, the non-small block sizes or semi-granular sizes of bulk materials, such as coal, sand, and dust coke, cement, water, ore, etc.
The characteristics of this machine for centrifugal discharging: and it is not suitable to used rubber conveyor belt for traction components conveying of bulk material with high milling performance and cut resistance.Conveying temperature not exceeding more than 60 degree, if the heat-resistant rubber band allowing 150 degrees.
This machine is a total of four specifications: D160, D250, D350, D450.
The machine is the transmission capacity of 3.1 m ~ 66 cubic meters(m3)/h at altitudes of 4~30 metres.In order to satisfy the different requirements, the machine has a variety of different preparation and installation method.
1, According to the shape of the hopper divided into two kinds
S method--the shape of the bottom with deep Park Hopper
Q process--with the shallow end of the garden-shaped hopper
2, According to the upper section of the form is divided into two kinds of discharge port
X1 the preparation--with a discharge port of the slant flange
X2 discharge port of the process--with horizontal flange
3, According to the form of the lower part of the inlet section is divided into two
J1 process--the angle of the inclined plane with oriontation of 45 inlet
J2 process--the angle of the inclined plane with oriontation of 60 inlet
4, Examine the position of the door by the side of the middle of the chassis is divided into four
K1 process--the side of the cabinet with the lower end of the middle-left view of the door
K2 process--the lower end of the middle of the side of the casing with a right view of the door
K3 process--the middle of the side of the cabinet with the top-left view of the door
K4 process--the middle of the side of the casing with upper right view of the door
5, Examine the position of the door by the middle of the casing end face is divided into two
Z1 process--the lower end of the middle of the casing end face with a view of the door
Z2 process--the intermediate casing end face with a top view of the door
6, According to the relative position of the transmission device of hoist is divided into two
The left--drives on the left
Right--drive on the right side